No Vrrp Preempt - Siemens SCALANCE XM-400 Configuration Manual

9.5.5.5

no vrrp preempt

Description
With this command, you specify that a virtual router with higher priority cannot interrupt a
virtual router with lower priority.
Note
This command is available only with layer 3.
Requirement
● An IP address is assigned to the virtual router.
● You are in the VRRP Interface Configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> preempt
The parameter has the following meaning:
Parameter
vrid
Result
The function is disabled.
Further notes
You configure a VRRP interface with the
You assign IP addresses to a virtual router with the
You enable the function with the
You can display the status of the function with the
show vrrp interface
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
ID of the virtual router
interface
vrrp preempt
command.
Range of values
1 ... 255
command.
vrrp associated -ip
command.
show vrrp interface - vrid
Layer 3 functions
9.5 VRRP
command.
or with the
443