Load control
10.3 Dynamic MAC aging
Result
The value of the aging of a dynamically learned entry is configured.
Further notes
You can reset the setting to the default with the
You display the setting with the
10.3.3.2
no mac-address-table aging-time
Description
With this command, you reset the value for the aging of a dynamically learned entry in the
MAC address list to the default value.
The default value is 40 s.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no mac-address-table aging-time
Result
The value of the aging of a dynamically learned entry is reset to the default value.
Further notes
You configure the setting with the
You display the setting with the
10.3.3.3
mac-address-table aging
Description
With this command, you enable the "Aging" function. The "Aging" function ensures that an
entry in the MAC address list that was learned dynamically is deleted again after a certain
time.
470
no mac-address-table aging-time
show mac-address-table aging-time
mac-address-table aging-time
show mac-address-table aging-time
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.
command.
command.
command.