Commands In The Interface Configuration Mode; Flowcontrol - Siemens SCALANCE XM-400 Configuration Manual

10.4.2

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
● If you exit the Interface configuration mode with the
10.4.2.1

flowcontrol

Description
The flow control function monitors a connection at the receiving end to make sure that not
more data is received than can be processed. If flow control detects a threat of data
overflow, the partner at the sending end is sent a signal to stop transmitting.
With this command, you configure the flow control function for an interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
flowcontrol {on|off}
The parameters have the following meaning:
Parameters
on
off
Result
The settings are configured.
Further notes
You can display the status of this function with the
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Global configuration mode.
Privileged EXEC mode.
Description
Enables the function
Disables the function
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
show flow-control
Load control
10.4 Flow control
command.
473