Layer 3 functions
9.3 OSPFv2
Result
Routing with OSPF is enabled.
You are now in the Router Configuration mode.
The command prompt is as follows:
cli (config-router)#
Further notes
You disable routing with OSPF with the
9.3.12.2
no router ospf
Description
With this command, you disable routing with OSPF.
Note
This command is available only with layer 3.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no router ospf
Result
Routing with OSPF is disabled.
Further notes
You enable routing with OSPF with the
370
command.
no router ospf
command.
router ospf
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07