No Switchport Mode - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport mode { trunk | hybrid }
The parameters have the following meaning:
Parameter Description
trunk
hybrid
Result
The operating mode is configured.
Further notes
You reset the operating mode to the default with the
You display this setting and other information with the
You configure the interface as a switch port with the
6.1.3.10

no switchport mode

Description
With this command, you reset the operating mode for the switch port to the default.
The default value is Hybrid.
Requirement
● The interface is configured as a switch port.
164
Configures the port as a trunk port that only forwards tagged frames. The port can then
only be configured as the trunk port if the port is not entered in any VLAN that
exchanges untagged frames.
For the trunk port to forward tagged frames, all VLAN IDs to which the trunk port
forwards frames must be stored.
If a new VLAN is created, the VLAN ID is automatically entered at the trunk port.
With a trunk port, the VLAN assignment is dynamic. Static configurations can only be
created if, in addition to the trunk port property, the port is also entered statically as a
member in the VLANs involved. An example of a static configuration is the assignment of
the multicast groups in certain VLANs.
If you execute the "
acceptable frame-type all
also receives untagged frames.
Configures the port as a hybrid port that accepts tagged and untagged frames.
" command at the trunk port, the port
no switchport mode
show vlan port config
command.
switchport
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.
command.