Spanning-Tree Bpdu-Transmit - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.3 Spanning Tree
Result
The automatic discovery of a bridge on the interface is disabled.
Further notes
The automatic discovery of a bridge on the interface is disabled with the
auto-edge
6.3.5.7

spanning-tree bpdu-transmit

Description
With this command, you enable or disable the BPDU transmit status at the port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree bpdu-transmit{enabled|disabled}
The parameters have the following meaning:
Parameter
enabled
disabled
Result
The BPDU transmit status has switched over.
Further notes
You can display the status of this function and other information with the
interface
212
command.
Description
BPDU packets are transmitted at the port
Default: enabled
BPDU packets are not transmitted at the port
command with the
detail
option.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
spanning-tree
show spanning tree