Siemens SCALANCE XM-400 Configuration Manual page 589

Syntax
Call up the command for the port to be monitored with the following parameter assignment:
monitor session<session-id(1-7)>{source
{interface<interface-type><interface-id>[{rx|tx|both}]}}
or
Call up the command for the VLAN to be monitored with the following parameter assignment:
monitor session <session-id (1-1)> {source
{vlan <vlan-id> | mac-acl <acl-id>}
The parameters have the following meaning:
Parameter
session-id
interface
interface-
type
interface-id
rx
tx
both
vlan-id
acl-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
If you do not select any parameters from the parameter list, the default value (both) is used.
Note
VLAN / ACL mirroring
Tx mirroring is not supported with VLAN or ACL monitoring.
Result
As soon as you have configured the settings for the port to be monitored and the destination
port, the session is complete and active.
Further notes
You delete the source for mirroring a port with the
You end and delete a session with the
You display the configuration settings with the
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Number of the session
7 parallel sessions are possible only with port-based
mirroring and their ports must not overlap.
Keyword for a an interface description
Type or speed of the interface
Slot no. and port no. of the interface
Received data traffic will be mirrored (received)
Transmitted data traffic will be mirrored (transmitted)
Received and sent data traffic will be mirrored
Number of the VLAN
Number of the Access Control List
no monitor session
Values
1..7
-
•
•
Enter a valid interface
name
-
-
-
1 .. 4094
no monitor session ... source
command.
show monitor session
Diagnostics
12.4 Port Mirroring
fastethernet
gigabitethernet
command.
command.
589