Ip Ospf Hello-Interval - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv2
9.3.14.9

ip ospf hello-interval

Description
With his command, you specify the interval between two Hello packets.
Note
This command is available only with layer 3.
Requirement
● The interface is a layer 3 interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf hello-interval <seconds (1 - 65535)>
The parameter has the following meaning:
Parameter
seconds
Result
The interval is specified.
Further notes
You delete the interval with the
You show the configuration of the OSPF interface with the
command.
406
Description
Interval in seconds
no ip hello-interval
Range of values / note
0 ... 65535
command.
show ip ospf interface
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07