Security and authentication
11.7 Port Based Network Access Control
11.7.4.4
no dot1x mac-auth
Description
With this command, you disable MAC authentication for the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no dot1x mac-auth
Result
MAC authentication is disabled for the device.
11.7.5
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
11.7.5.1
dot1x guest-vlan
Description
With this command, you enable the guest VLAN function for a port.
Requirement
You are in the Interface configuration mode.
530
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07