No Spanning-Tree - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

no spanning-tree

With this command, you reset the various properties of the spanning tree function to the

default value:

The default values are as follows:

port-priority

You are in the Interface configuration mode.

The command prompt is as follows:

cli(config-if-$$$)#

Call up the command with the following parameters:

no spanning-tree {cost|disable|link-type|portfast|port-priority}

The parameters have the following meaning:

SCALANCE XM-400/XR-500 Command Line Interface

Configuration Manual, 05/2014, C79000-G8976-C252-07

Default value

if dynamic calculation of the path costs is not enabled:

200000 for physical interfaces

199999 for port channels

The spanning tree function is enabled on the interface

point-to-point

The connection is configured as

in all other cases

Keyword for the costs of the port for calculating the lowest-cost path.

Enables the interface for spanning tree.

Connection status of the following network segment

Disables the PortFast function.

Keyword for the priority of the interface

Network structures

6.3 Spanning Tree

Scalance xr-500