No Vrrp Primary-Ip - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

no vrrp primary-ip

With this command, you remove an IP address from the virtual router.

This command is available only with layer 3.

You are in the VRRP Interface Configuration mode.

The command prompt is as follows:

cli (config-vrrp-if)#

Call up the command with the following parameters:

no vrrp <vrid(1-255)> ipv4 <ucast_addr > [secondary]}]

The parameters have the following meaning:

The IP address is removed from the virtual router.

Further notes

You configure a VRRP interface with the

You assign IP addresses to a virtual router with the

You display the IP addresses with the

SCALANCE XM-400/XR-500 Command Line Interface

Configuration Manual, 05/2014, C79000-G8976-C252-07

ID of the virtual router

Value for an IPv4 unicast address

Secondary IP addresses

show vrrp interface - vrid

Range of values

Enter a valid IPv4 unicast address

vrrp associated-ip

Layer 3 functions

Scalance xr-500