Ip Ospf Retransmit-Interval - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
no ip ospf message-digest-key <Key-ID (0-255)>
The parameter has the following meaning:
Parameter
Key-ID
Result
The password is deleted.
Further notes
You specify the password with the
9.3.14.13

ip ospf retransmit-interval

Description
With this command, you specify the time after which an LSA message is transferred again if
no confirmation has been received.
Note
This command is available only with layer 3.
Requirement
● The interface is a layer 3 interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf retransmit-interval <seconds (0 - 3600)>
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
ID of the password
ip ospf message-digest-key
Range of values / note
Enter a valid ID.
command.
Layer 3 functions
9.3 OSPFv2
409