Siemens SCALANCE XM-400 Configuration Manual page 511

Requirement
You are in the ACL standard configuration mode.
The command prompt is as follows:
cli(config-std-nacl)#
Syntax
Call up the command with the following parameters:
permit udp {any | host <src-ip> | <network-src-ip> <mask>} [{ gt <port-number(1-
65535)> | lt <port-number(1-65535)> | eq <port-number(1-65535)> | range <port-number
(1-65535)> <port-number (1-65535)>}] [{any | host <dest-ip> | <network-dest-ip>
<mask>}] [{ gt <port-number(1-65535)> | lt <port-number(1-65535)> | eq <port-
number(1-65535)> | range <port-number (1-65535)> <port-number (1-65535)>}]
[dscp<value(0-63)>]
The parameters have the following meaning:
Parameter
any
host
src-ip
network-src-ip
mask
port-number
gt
lt
eq
range
any
host
dest-ip
network-dest-ip
mask
dscp
value
Result
The IP access list for UDP datagrams has been configured.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Forwards all incoming TCP segments.
Keyword for a 32 bit long subnet mask.
Source IP address
Network source address
Corresponding subnet mask
Port number
Keyword for port numbers higher than the
specified number (gt: greater than).
Keyword for port numbers lower than the
specified number (lt: less than).
Keyword for a specific port number (eq:equal).
Keyword for a range of port numbers.
Following this, the first and last port number of
the range is specified.
Forwards all outgoing TCP segments.
Keyword for a 32 bit long subnet mask.
Destination IP address
Network destination address
Corresponding subnet mask
Keyword for the Differentiated Services
Codepoint
Value for the Differentiated Services Codepoint 0 ... 63
Security and authentication
11.4 IP access control list
Values
-
-
enter a valid IP address.
enter a valid combination of
IP address and subnet mask.
1 ... 65535
-
-
-
-
-
-
enter a valid IP address.
enter a valid combination of
IP address and subnet mask.
-
511