No Ring-Redundancy Standby; Commands In The Redundancy Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.4 Ring redundancy and standby connection
8.4.5.5

no ring-redundancy standby

Description
With this command, you disable the standby function.
Requirement
● HRPis activated
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ring-redundancy standby
Result
The standby function is disabled.
Further notes
You enable the setting with the
You can display the status of this function and other information with the
redundancy
8.4.6

Commands in the redundancy configuration mode

This section describes commands that you can call up in the Redundancy Configuration
mode.
In the Global Configuration mode, enter the
change to this mode.
● If you exit the Redundancy Configuration mode with the
Global Configuration mode.
● If you exit the Redundancy Configuration mode with the
Privileged EXEC mode.
338
ring-redundancy standby
command.
command.
ring-redundancy configuration
command, you return to the
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
show ring-
command to