Alias; Duplex - Siemens SCALANCE XM-400 Configuration Manual

3.1.11.1

alias

Description
With this command, you assign a name to an interface. The name only provides information
and has no effect on the configuration.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
alias <port-name>
The parameter has the following meaning:
Parameters
port-name
Result
The interface is assigned a name.
3.1.11.2

duplex

Description
Certain interfaces can be operated in full duplex mode or half duplex mode. The options here
depend on the connected device.
Optical connections, for example, are always operated in full duplex mode since they have a
fiber for each transmission direction.
With this command, you configure the duplex mode of an interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Name of the interface
Configuration
3.1 System
max. 63 characters
67