Show Mac-Address-Table Dynamic Multicast; Show Mac-Address-Table Static Multicast - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 2 management protocols

8.6 Multicast

show mac-address-table dynamic multicast

This command shows the MAC addresses of the dynamic multicast configurations.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Call up the command with the following parameters:

show mac-address-table dynamic multicast [vlan <vlan-range>] [address

<aa:bb:cc:dd:ee:ff>] [{interface <interface-type> <interface-id>}]

The parameters have the following meaning:

interface-id

If you do not select any parameters from the parameter list, the default value is used.

For information on names of addresses and interfaces, refer to the section "Auto-Hotspot".

The table is displayed.

This command shows the MAC addresses of the static multicast configurations.

Keyword for a VLAN

Keyword for several VLANs

Keyword for a MAC address

Keyword for a an interface description

Type of interface

Slot no. and port no. of the interface

Range of values / note

aa:bb:cc:dd:ee:ff

gigabitethernet

extreme-ethernet

# digit /digit#

Slot: 0 ... 6 or 12

Port: 1 ... 4

SCALANCE XM-400/XR-500 Command Line Interface

Configuration Manual, 05/2014, C79000-G8976-C252-07

Scalance xr-500