No Poe Prio - Siemens SCALANCE XM-400 Configuration Manual

The placeholders $-$ stand for the numbering of the interface.
Syntax
Call up the command with the following parameters:
poe prio {low|high|critical}
The parameters have the following meaning:
Parameters
low
high
critical
Result
The priority of the corresponding interface has been specified.
3.5.4.6

no poe prio

Description
With this command, you set the priority of an interface to the default value "low".
Requirement
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-Gi$-$)#
The placeholders $-$ stand for the numbering of the interface.
Syntax
Call the command without parameters:
no poe prio
Result
The priority of the corresponding interface has been set to "low".
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
low priority
medium priority
high priority
Configuration
3.5 PoE
101