Mac-Address-Table Static Multicast - Siemens SCALANCE XM-400 Configuration Manual

Load control
10.2 Static MAC filtering
Further notes
You delete the static multicast MAC address with the
multicast
10.2.1.2

mac-address-table static multicast

Description
With this command, you generate a static multicast MAC address entry in the forwarding
database.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table static multicast<aa:bb:cc:dd:ee:ff>
The parameters have the following meaning:
Parameter
-
vlan
vlan-id
interface
interface-
type
0/a-b,
0/c,...
port-channel
forbidden-
ports
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
462
command.
vlan<vlan-id(1-4094)>
interface([<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
[port-channel<1-8>]])
[forbidden-ports([<interface-type><0/a-b,0/c,...>]
[<interface-type><0/ab,0/c, ...>]
[port-channel <1-8>]])
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a an interface description
Type of interface
Slot no. and port no. of the interface
Specifies the name of a port channel
Keyword for the interface description of the blocked
ports
no mac-address-table static
Values or range of values
aa:bb:cc:dd:ee:ff
-
1 ... 4094
-
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
1-8
-
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07