No Area Range - Siemens SCALANCE XM-400 Configuration Manual

Parameter
advertise
notadvertise
Result
The address range is configured.
Further notes
You delete the address range with the
You can display the status of this function and other information with the
area-range / summary-address
9.3.13.5

no area range

Description
With this command, you delete the address range.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
area <AreaId> range <Network> <Mask>
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
The address range is advertised outside the
ranges.
If the Area ID is 0.0.0.0, the router generates
an LSA message of Type 5.
If the Area ID is not 0.0.0.0, the router
generates an LSA message of Type 7 in an
NSSA.
The address range is not advertised to the
outside.
no area range
command.
Layer 3 functions
Range of values / note
-
-
command.
show ip ospf -
9.3 OSPFv2
375