No Switchport Priority Default; Switchport Pvid - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
Result
The setting is configured.
Further notes
You reset the default priority to the default value with the
command.
You display this setting and other information with the
6.1.3.12

no switchport priority default

Description
With this command, you reset the default priority for the interface to the default value.
The default value is 0.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport priority default
Result
The setting is reset to the default value.
Further notes
You configure the default priority with the
You display this setting and other information with the
6.1.3.13

switchport pvid

Description
With this command, you assign an interface to a VLAN and configure the port VLAN
identifier (PVID) for it. If a received frame has no VLAN tag, it has a tag added with the
VLAN-ID specified here and is sent according to the switch rules for the port.
166
no switchport priority default
show vlan port config
switchport priority default
show vlan port config
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.
command.
command.