No Ntp Server - Siemens SCALANCE XM-400 Configuration Manual

System time
5.2 NTP client
5.2.3.2

no ntp server

Description
With this command, you delete the connection to a server on the NTP client.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Syntax
Call up the command with the following parameters:
no ntp server {ipv4 <ip_addr> | fqdn-name <FQDN(100)>}
The parameters have the following meaning:
Parameter
ipv4
ip_addr
fqdn-name
FQDN(100)
Result
The connection to a server is deleted on the NTP client.
Further notes
You configure the connection to a server with the
126
Description
Keyword for an IPv4 address
Value for the IPv4 address of the time server
Keyword for a domain name
Domain name (Fully Qualified Domain Name)
Range of values / note
-
Enter a valid IPv4 address
-
Maximum of 100 characters
command.
ntp server
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07