Link Aggregation; Show Etherchannel - Siemens SCALANCE XM-400 Configuration Manual

Network structures

6.2 Link aggregation

6.2 Link aggregation
This section describes commands that configure or manage the bundling of interfaces or
connections between devices.
6.2.1

show etherchannel

Description
This command shows the settings of the Etherchannel.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show etherchannel [[channel-group-number]
The parameters have the following meaning:
Parameter
channel-group-number
detail
load-balance
port
port-channel
summary
protocol
If you do not select any parameters from the parameter list, the settings of all channels will
be displayed in detail.
Result
The Etherchannel settings are displayed.
176
or
cli#
{detail|load-balance|port|port-channel|summary|protocol}]
Description
Number of the channel-group
Detailed display of the settings
Shows which load balancing method is enabled
Information on the Etherchannel port
Information on the port-channel
Brief overview of the settings of a channel-group
Specification of the protocol set for a channel-group
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07