Commands In The Global Configuration Mode; Authorized-Manager - Siemens SCALANCE XM-400 Configuration Manual

11.6.2

Commands in the Global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
11.6.2.1

authorized-manager

Description
With this command, you enable the authorized manager.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
authorized-manager
Result
The function is enabled.
Further notes
You disable the function with the
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
11.6 Management Access Control List
configure terminal
or
end exit
no authorized-manager
Security and authentication
command to change to this mode.
command and are then in the
command.
521