Show Interface Transceiver Details - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.1 Event and fault handling
Requirement
● The interface has no active data traffic
● The
Configuration mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show cabletest interface <iftype> <if-id>
The parameters have the following meaning:
Parameter
iftype
if-id
For information on names of addresses and interfaces, refer to the section "Auto-Hotspot".
Result
The result of the cable test of the interface is displayed.
Further notes
You enable the setting with the
mode.
See also
Addresses and interface names (Page 30)
12.1.11

show interface transceiver details

Description
This command runs error diagnostics for an SFP port.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
548
cabletest interface
or
cli#
Description
Type of interface
Interface identifier
function was used on the specified interface in the Global
cabletest interface
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Range of values / note
command in the Global Configuration