Network structures
6.3 Spanning Tree
Parameter
disable
link-type
portfast
port-priority
Note
Configure multiple properties
Each time the command is called, you can configure precisely one property.
If you want to configure more than one property, call up the command more than once.
Result
The selected setting is configured.
Further notes
You can reset the setting to the default with the
You display these settings and other information with the commands that start with
spanning tree ...
206
Description
disables the interface for spanning tree
Connection status of the following network
segment
Enables the PortFast function
Priority of the interface
.
Range of values
-
Default:
The spanning tree function is
enabled on the interface
•
point-to-point
•
shared
Default:
•
point-to-point
The connection is
configured as
duplex
•
shared
in all other cases
-
Default: disabled
0 ... 240 in steps of 16
Default: 128
(properties) command.
no spanning-tree
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
full-
show