No Mac Access-Group; Commands In The Mac Acl Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

11.3.4.2

no mac access-group

Description
With this command, you disable the access control of the packets of an interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no mac access-group <access-list-number(1-128)>{in|out}
The parameters have the following meaning:
Parameters
access-list-number
in
out
Result
The packet filtering according to the access control list (ACL) is canceled.
Further notes
You enable the setting with the
You display the configuration of the access control list with the
11.3.5

Commands in the MAC ACL configuration mode

This section describes commands that you can call up in the MAC ACL configuration mode.
In the Global configuration mode, enter the
to this mode.
● If you exit the MAC ACL configuration mode with the
● If you exit the MAC ACL configuration mode with the
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Number of the access control list
Specifies that incoming packets are filtered
Specifies that outgoing packets are filtered
Global configuration mode.
Privileged EXEC mode.
command.
mac access-group
mac access-list extended
Security and authentication
11.3 MAC access control list
Values
1 ... 128
-
-
show access-lists
command to change
command, you return to the
exit
command, you return to the
end
command.
491