Dhcp Relay; Show Dhcp Server - Siemens SCALANCE XM-400 Configuration Manual

7.3

DHCP Relay

This section describes commands for the DHCP Relay Agent.
7.3.1

show dhcp server

Description
With this command, you display the IP addresses of the DHCP servers to which the device
forwards the frames.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode or in the Global
Configuration mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show dhcp server
Result
The IP addresses of the DHCP servers are displayed.
Further notes
With the "
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
or or
cli# cli(config)#
" command, you specify the IP addresses.
ip dhcp server
Network protocols
7.3 DHCP Relay
257