Sntp; Commands In The Sntp Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

System time
5.3 SNTP client
5.3.4.1

sntp

Description
With this command, you change to the SNTP configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
sntp
Result
You are now in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Further notes
You exit the SNTP configuration modewith the
5.3.5

Commands in the SNTP configuration mode

This section describes commands that you can call up in the SNTP configuration mode.
In the Global configuration mode, enter the
● If you exit the SNTP configuration mode with the
configuration mode.
● If you exit the SNTP configuration mode with the
Privileged EXEC mode.
130
or command.
end exit
command to change to this mode.
sntp
command, you return to the Global
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07