Show Sntp Status; Commands In The Global Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

show sntp unicast-mode status
Result
The current SNTP unicast configuration is displayed.
5.3.3

show sntp status

Description
This command shows the settings of SNTP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show sntp status
Result
The settings are displayed.
5.3.4

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
or
cli#
command to change to this mode.
configure terminal
or
end exit
System time
5.3 SNTP client
command and are then in the
129