Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ports
The parameters have the following meaning:
Parameter
interface-type
/a-b,0/c,...
port-channel
/a-b,0/c,...
untagged
all
forbidden
name
vlan-name
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
(
[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
[port-channel<a,b,c-d>]
)
[
untagged<interface-type> <0/a-b,0/c,...>
(
[<interface-type><0/a-b,0/c,...>]
[port-channel <a,b,c-d>]
[all]
)
]
[
forbidden<interface-type><0/a-b,0/c,...>
[<interface-type><0/a-b,0/c,...>]
[portchannel<a,b,c-d>]
]
[name<vlan-name>]
Description
Type or speed of the interface
Port no. of the interface
Keyword for a port channel
Port no. of the interface
Keyword for interfaces or ports that transfer
data packets without VLAN marking
Specifies that all interfaces or ports are set to
"untagged"
Keyword for forbidden interfaces or ports
Keyword for the name assignment
Name of the VLAN
Network structures
6.1 VLAN
Values
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
-
Enter a valid interface name
-
-
-
-
max. 32 characters
169