Show Interface Access Lists; Commands In The Global Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

11.3.2

show interface access lists

Description
This command shows the access control list of one or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show interface access-lists<interface-type><interface-id>]
The parameters have the following meaning:
Parameters
interface-
type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available IP interfaces.
Result
The access control list of the selected IP interface is displayed.
11.3.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
or
cli#
Description
Type or speed of the interface
Slot no. and port no. of the interface
command to change to this mode.
configure terminal
or
end exit
Security and authentication
11.3 MAC access control list
Values
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
command and are then in the
487