Show Ip Interface - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

show ip interface

This command shows the configuration of one, several or all IP interfaces.

You are in the User EXEC mode or in Privileged EXEC.

The command prompt is as follows:

Call up the command with the following parameters:

show ip interface [Vlan<vlan-id(1-4094)>]

The parameters have the following meaning:

interface-id

For information on names of addresses and interfaces, refer to the section "Addresses and

interface names (Page 30)".

If you do not select any parameter from the parameter list, the configuration is displayed for

all available IP interfaces.

The configuration of the selected IP interface is displayed.

SCALANCE XM-400/XR-500 Command Line Interface

Configuration Manual, 05/2014, C79000-G8976-C252-07

[<interface-type><interface-id>]

[loopback<loopback-id(0)>]

Keyword for a VLAN connection

Number of the addressed VLAN

Type or speed of the interface

Slot no. and port no. of the interface

Keyword for a loopback

Number of the addressed loopback

Configuration

gigabitethernet

extreme-ethernet

Enter a valid interface name

Scalance xr-500