9.3.13.3
area range
Description
With this command, you assign an area ID an address range. The address range is used to
group the routes within OSPF.
Note
This command is available only with layer 3.
Requirement
● The router is an area border router
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
area <AreaId> range
<Network>
<Mask>
[{
advertise | notadvertise
}]
The parameters have the following meaning:
Parameter
AreaId
Network
Mask
advertise
notadvertise
Result
The address range is configured.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Area ID
IP address of the address range
Subnet mask of the address range
The address range is advertised to the outside.
A summary LSA of Type 3 is generated.
The address range is not advertised to the
outside.
Layer 3 functions
9.3 OSPFv2
Range of values / note
specify an ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
specify the IP address
specify the subnet mask.
-
-
373