No Monitor Session - Siemens SCALANCE XM-400 Configuration Manual

Result
The source for the mirroring of a port is deleted.
Further notes
You configure the source for mirroring a port with the
You end and delete a session with the
You display the configuration settings with the
12.4.4.9

no monitor session

Description
With this command, you delete the monitor session.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no monitor session<session-id(1)>
The parameter has the following meaning:
Parameter
session-id
Result
The monitor session is deleted.
Further notes
You display the configuration settings with the
You configure and start mirroring of a port with the
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
no monitor session
Description
Number of the session
7 parallel sessions are possible
only with port-based mirroring and
their ports must not overlap.
monitor session ... source
command.
show monitor session
Range of values
1 .. 7
show monitor session
command.
monitor session
Diagnostics
12.4 Port Mirroring
command.
command.
command.
591