No Dot1X Mac-Auth; Dot1X Mac-Auth Port Reset - Siemens SCALANCE XM-400 Configuration Manual

11.7.5.8

no dot1x mac-auth

Description
With this command, you disable MAC authentication for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x mac-auth
Result
MAC authentication is disabled for a port.
11.7.5.9

dot1x mac-auth port reset

Description
With this command, you reset MAC authentication for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x mac-auth port [mac <aa:aa:aa:aa:aa:aa>] reset
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Security and authentication
11.7 Port Based Network Access Control
535