Result
The information of the OSPF interface is displayed.
9.3.7
show ip ospf neighbor
Description
This command shows information about the detected neighboring routers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip ospf neighbor
[{
}]
[Neighbor ID]
[detail]
The parameters have the following meaning:
Parameters
Vlan
vlan-id
interface-
type
interface-id
Neighbor ID
detail
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
or
cli#
vlan <vlan-id(1-4094)>|<interface-type><interface-id>
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Slot no. and port no. of the interface
Router ID of the neighbor
OSPF information on the neighbor
Layer 3 functions
9.3 OSPFv2
Values
-
1 ... 4094
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
The ID consists of 4 numbers
each between 0 and 255 and
can match the IP address of
the router.
365