Commands In The Autolearn Mode; Start - Siemens SCALANCE XC-200 Configuration Manual

Security and authentication
11.4 Port Access Control List Locked Ports
You display the configuration with the show lock port command.
11.4.4

Commands in the AUTOLEARN mode

This section describes commands that you can call up in the AUTOLEARN mode.
In the Global configuration mode, enter the auto-learn command to change to this mode.
● If you exit the AUTOLEARN mode with the exit command, you return to the Global
configuration mode.
● If you exit the AUTOLEARN mode with the end command, you return to the Privileged
EXEC mode.
11.4.4.1

start

Description
With this command, you start automatic learning. During automatic learning, the aging timer
is disabled for all learned addresses.
Requirement
You are in the AUTOLEARN mode.
The command prompt is as follows:
cli(config-auto-learn)#
Syntax
Call the command without parameters:
start
Result
The learned MAC addresses are entered in the "port database" with the aging time 0. (The
entries are NOT deleted when the "MAC Address Aging Time" expires).
Further notes
You stop automatic learning with the stop command.
522
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06