Commands In The Vrrp Router Configuration Mode; Interface - Siemens SCALANCE XM-400 Configuration Manual

Result
Routing with VRRP is disabled.
Further notes
You enable routing with VRRP with the
9.5.4

Commands in the VRRP Router Configuration mode

This section describes commands that you can call up in the VRRP Router Configuration
mode.
In the Global Configuration mode, enter the
● If you exit the VRRP Router Configuration mode with the
● If you exit the VRRP Router Configuration mode with the
9.5.4.1

interface

Description
With this command, you decide the interface for which you want to assign parameters in the
VRRP Configuration mode.
There you can edit the settings for a VRRP interface. You select the VRRP interface with the
parameters of this command.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Router Configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call up the command with the following parameters:
interface{vlan<vlan-id(1-4094)
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
the Global Configuration mode.
Privileged EXEC mode.
<interface-type><interface-id>}
command.
router vrrp
command to change to this mode.
router vrrp
exit
end
Layer 3 functions
9.5 VRRP
command, you return to
command, you return to the
435