Sntp Client Addressing-Mode - Siemens SCALANCE XM-400 Configuration Manual

5.3.5.1

sntp client addressing-mode

Description
With this command, you configure the addressing mode of the SNTP client as unicast,
multicast, broadcast or anycast.
Requirement
● The SNTP client is activated.
You are in the SNTP Configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp client addressing-mode{unicast|broadcast}
The parameters have the following meaning:
Parameter
unicast
broadcast
Result
The addressing mode of the SNTP client is configured.
Further notes
You display this setting and other information with the
You display the settings for the unicast mode with the
command.
You display the settings for the broadcast mode with the
command.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
configures the SNTP client in unicast mode
Default: unicast enabled
configures the SNTP client in brodcast mode
command.
show sntp status
show sntp unicast-mode status
show sntp broadcast-mode status
System time
5.3 SNTP client
131