No Switchport Pvid - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport pvid <vlan-id(1-4094)>
The parameter has the following meaning:
Parameters
vlan-id
Result
The PVID is configured
Further notes
You can reset the setting to the default with the
You display the setting and other information with the
6.1.3.14

no switchport pvid

Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport pvid
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Number of the addressed VLAN
Range of values
1 ... 4094
command.
no switchport pvid
show vlan port config
Network structures
6.1 VLAN
command.
167