Commands In The Qos Configuration Mode; Cos-Map - Siemens SCALANCE XM-400 Configuration Manual

Load control
10.5 Service classes
10.5.4

Commands in the QOS configuration mode

This section describes commands that you can call up in the QOS configuration mode.
In the Global configuration mode, enter the
● If you exit the QOS configuration mode with the
configuration mode.
● If you exit the QOS configuration mode with the
Privileged EXEC mode.
10.5.4.1

cos-map

Description
In a network, each data stream is assigned a service class that decides its priority. In special
situations, it may be necessary to change this priority.
This change is made using a table in which the service classes are assigned to another
queue.
With this command, you configure the assignment table for service classes.
Requirement
You are in the QOS Configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call up the command with the following parameters:
cos-map <cos(0-7)> queue <queue(1-8)>
The parameters have the following meaning:
Parameter
cos
queue
For the following default service classes, the rule applies accordingly.
Result
The assignment table for service classes is configured.
476
Description
Service class
Queue that it is assigned to this service class
command to change to this mode.
qos
command, you return to the Global
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Range of values
0 ... 7
Default: 1
1 ... 8
Default: 2