Commands In The Events Configuration Mode; Add Log - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.1 Event and fault handling
12.1.14

Commands in the Events configuration mode

This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
Privileged EXEC mode.
12.1.14.1

add log

Description
With this command, you make an entry in the logbook.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call the command without parameters:
add log <log entry>
The parameter has the following meaning:
Parameters
log entry
Result
The entry has been made in the logbook.
552
events
Description
Entry in the logbook
Configuration Manual, 05/2014, C79000-G8976-C252-07
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Note
max. 150 characters
SCALANCE XM-400/XR-500 Command Line Interface