Commands In The Global Configuration Mode; Spanning-Tree - Siemens SCALANCE XM-400 Configuration Manual

6.3.4

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
6.3.4.1

spanning-tree

Description
The Spanning Tree Protocol is used to monitor a LAN for redundant connections. These are
blocked and reactivated when necessary if there are changes to the network topology.
With this command, you enable the spanning tree function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
spanning-tree
Result
The spanning tree function is enabled.
Further notes
As default the function is "enabled".
You disable the spanning tree function with the
You can display the status of this function and other information with the
detail
You can display information about active ports with the
command.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.
command to change to this mode.
configure terminal
or
end exit
no spanning tree
show spanning tree active
Network structures
6.3 Spanning Tree
command and are then in the
command.
show spanning tree
193