Network Area - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv2
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no default-information originate always
The parameters have the following meaning:
Parameter
metric
metric-value
metric-type
Type
Result
The function is disabled.
Further notes
You enable the function with the
9.3.13.17

network area

Description
With this command, you specify an OSPF interface and the Area ID connected to the OSPF
interface.
Note
This command is available only with layer 3.
388
[metric <metric-value (0-0xffffff)>]
[metric-type <type (1-2)>]
Description
Keyword for the metric of the external
standard route.
Value of the metric
Keyword for the type of the external
standard route
Type of the external route
Range of values / note
--
0-0xffffff
--
•
•
default-information originate always
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
1 - type 1
2 - type 2
command.