Switchport Acceptable-Frame-Type - Siemens SCALANCE XM-400 Configuration Manual

Result
The subnet with subnet mask and subnet address is assigned to a VLAN.
Further notes
You cancel the setting with the
You can display the status of this function and other information with the
mapping
6.1.3.3

switchport acceptable-frame-type

Description
With this command, you configure which types of frames are accepted.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged}
The parameters have the following meaning:
Parameter
all
tagged
Result
The setting is enabled.
Further notes
You can reset the setting to the default with the
command.
You can display the status of this function and other information with the
config
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.
command.
command.
no map subnet
Description
All frames are accepted.
Default:
all
Untagged frames are discarded.
no switchport acceptable-frame-type
Network structures
6.1 VLAN
show subnet-vlan
show vlan port
159