No Vrrp Associated-Ip - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRP
Result
The IP addresses are specified.
Further notes
You can create a maximum of 52 virtual IP addresses.
You configure a VRRP interface with the
You remove an IP address with the
You remove all IP addresses with the
You display the IP addresses with the
9.5.5.2

no vrrp associated-ip

Description
With this command, you remove an IP address from the virtual router.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Interface Configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> associated-ip <ip_addr>
The parameters have the following meaning:
Parameter
vrid
ip_addr
Result
The IP address is removed from the virtual router.
440
interface
no vrrp associated-ip
vrrp group shutdown
show vrrp interface - vrid
Description
ID of the virtual router
Value for an IP address
command.
command.
command.
command.
Range of values
1 ... 255
specify a valid IP address
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07