9.3.14.15
ip ospf transmit-delay
Description
With this command, you delete the interval.
Note
This command is available only with layer 3.
Requirement
● The interface is a layer 3 interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ip ospf transmit-delay
Result
The interval is deleted.
Further notes
You create the interval with the
9.3.14.16
no ip ospf transmit-delay
Description
With this command, you delete the interval.
Note
This command is available only with layer 3.
Requirement
● The interface is a layer 3 interface.
You are in the Interface Configuration mode.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.
ip transmit-delay
Layer 3 functions
9.3 OSPFv2
411