System time
5.1
System time setting
This section describes commands relevant for the configuration of the system time.
5.1.1
show time
Description
This command shows the settings of the system clock.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show time
Result
The settings for the system clock are displayed.
5.1.2
show dst info
Description
This command shows all the entries for daylight saving time stored on the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
or
cli#
or
cli#
5
117