Commands In The Vlan Configuration Mode For An Interface; Ip Rip Default Route Originate - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.4 RIPv2
9.4.4

Commands in the VLAN configuration mode for an interface

This section describes commands that you can call up in the VLAN configuration mode for
an interface or in the configuration mode for a router port.
In the Global configuration mode, enter the
VLAN configuration mode for an interface ($$$ indicates the numbering of the interface).
To change to the configuration mode for a router port, the following entries are necessary:
● In the Global configuration mode, enter the
<itype> is the interface type and $$$ the numbering of the interface.
● If the interface is a router port, the command prompt is displayed as follows:
CLI(config-if-RPort-...)
● If the interface is not a router port, the following command prompt appears:
CLI(config-if-...)
You can then make this report a router port with the following command sequence:
CLI(config-if-...) shutdown; no switchport; no shutdown
The command prompt takes the form
CLI(config-if-RPort-...)
If you exit the RIPv2 Router configuration mode with the
Global configuration mode.
If you exit the RIPv2 Router configuration mode with the
Privileged EXEC mode.
9.4.4.1

ip rip default route originate

Description
This command enables the forwarding of a default route.
Requirement
You are in the VLAN configuration mode of the VLAN interface with the ID $$$ or in the
configuration mode for a router port.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
or
cli(config-if-RPort-%%$$$)#
where %% is a short name for the interface type and $$$ is the numbering of the interface.
Syntax
Call up the command with the following parameters:
ip rip default route originate <metric(1-15)>
The parameter has the following meaning:
426
command, to change to the
interface vlan $$$
interface <itype> $$$
command, you return to the
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command, where