Port Based Network Access Control; Show Dot1X - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication

11.7 Port Based Network Access Control

11.7 Port Based Network Access Control
This section describes commands for working with port-based network access control
(PNAC).
11.7.1

show dot1x

Description
This command shows information about port-based network access control (PNAC).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show dot1x[{interface<interface-type><interface-id>|
The parameters have the following meaning:
Parameters
interface
interface-type
interface-id
statistics
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The dot1x information is displayed.
526
or
cli#
statistics interface<interface-type><interface-id>}]
Description
Keyword for a an interface description
Type or speed of the interface
Slot no. and port no. of the interface
Keyword for the display of the statistical
data of the dot1x Authenticator for an
interface
Type or speed of the interface
Slot no. and port no. of the interface
Values
-
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
-
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07